Page 30 - Series-4 Neon-Flex manual
P. 30
30
4.2 For Light with Injection-molded Connector Fittings Ledpro copyright
Keep 10~20 mm distance Keep 10~20 mm distance
Ensure the injection-moudled end Ensure the injection-moudled end
cap to be installed in the profile. cap to be installed in the profile.
Ensure the power cable is not subject to mechanical
stress at the beginning.
Ensure the injection-moudled front connector (top end) and end cap to be
installed in the profile.
Mechanical stress on front connector cable shall be avoided. The space between connector and mounting profile less than 10mm
is forbidden.
<10 mm
It is forbidden to curl or pull the front connector cable with It is forbidden to curl or pull the front connector cable with excessive
excessive force. force.
It is forbidden to force the injection-moulded end to fit into the
mounting profile and make light deformation.
