Page 5 - Series-4 Neon-Flex manual
P. 5
05 Ledpro copyright
Cautions
1. Before making any cuts, installation, maintenance or
Ф300 mm
connection, be sure the mains is disconnected!
2. All connector joints must be connected correctly to achieve
IP68 rating.
3. Please operate this flex light by instructions, and confirm the
work voltage, it must be matched with product requirements.
Keep the min. bend diameter 300mm
4. Please confirm the polarity of connector before inserting
front connector and energizing the mains power.
5. Connect and cut this light correctly. Any wrong operation will
damage this light.
6. Using qualified DC power supply.
7. Please correctly use and bend this Neon-Flex, see the
figures on the right.
8.Do not operate light when ambient temperature exceeds the
range of specified temperature in User Manual. Light Surface
9.Do not energize the light over 30 minutes in coil packaging.
10.Do not mix the four colors (R,G,B,W) in full load
(VB)Vertical Bending
simultaneoursly.
Light Surface
Light Surface
Light Surface
WARNING: The above wrong approaches will damage the light.